Jump to content
Create New...
  • William Maley
    William Maley

    Frankfurt Motor Show: Kia Previews the Next Sportage

      Kia Reveals the Next Sportage


    After some leaks showing off the vehicle, Kia has decided to release some pictures of the next-generation Sportage before its official debut at Frankfurt Motor Show next month.

     

    Compared to the current Sportage, the new model is much bolder thanks to a lower and wider “tiger nose” grille, new headlights, and wider fenders. Kia designer's retain the distinctive swept-back silhouette of the current model.

     

    We don't have any details on the interior or powertrains. Kia is keeping those under wraps till next month.

     

    Source: Kia

     

     

    Press Release is on Page 2


     

    Dynamic energy: Bold new exterior design for next-generation Kia Sportage

     

    Kia Motors has today revealed the first official exterior images of the all-new Kia Sportage, featuring an attractive new design. The all-new Sportage will make its global debut at the Frankfurt International Motor Show on 15 September 2015.
    Entering its fourth-generation, the all-new Kia Sportage features a bold, progressive design, with the vehicle's designers creating a sense of power and agility from every angle. Echoing the contrast of smooth and sharp shapes found on some of the most iconic modern fighter jets, the Sportage creates visual harmony out of the tension between sharp, defined feature lines and smooth surfacing.
    The 'face' of the all-new Sportage represents the biggest change to the car's design, with the car's headlamps no longer integrated with the grille for the new model, instead sweeping back along the outer edges of the more sharply-detailed bonnet and bolder wheel arches. Immediately recognisable as a Kia, the Sportage's lower, wider 'tiger-nose' grille adds more volume to the lower half of the Sportage's face, resulting in a more imposing appearance and a more stable-looking stance.
    The all-new Sportage is characterised by its sportier, more raked profile. From the side, the all-new Sportage retains the swept-back silhouette of the outgoing model, with a roofline that tapers slightly towards the rear of the car, longer front overhangs, shorter rear overhangs and longer wheelbase. Smooth bodywork, bolder wheel arches and sharp lines endow the Sportage with a more dynamic, muscular look.
    At the rear, the horizontal forms and surface volume emphasise the car's width and give the compact SUV a more stable appearance. Inspired by the 2013 Kia Provo concept car, the slim combination lamps are joined by a strip that runs the width of the rear, while turn signals and reversing lights are separated, relocated lower down to add more visual weight and a greater sense of stability to the lower half of the car.
    The design of the new Sportage has been led by Kia's European design studio in Frankfurt, Germany, with input from the brand's Namyang, Korea and Irvine, California design centres

    User Feedback

    Recommended Comments



    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest
    Add a comment...

    ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.


  • google-news-icon.png



  • google-news-icon.png

  • Subscribe to Cheers & Gears

    Cheers and Gears Logo

    Since 2001 we've brought you real content and honest opinions, not AI-generated stuff with no feeling or opinions influenced by the manufacturers.

    Please consider subscribing. Subscriptions can be as little as $1.75 a month, and a paid subscription drops most ads.*
     

    You can view subscription options here.

    *a very limited number of ads contain special coupon deals for our members and will show

  • Community Hive Community Hive

    Community Hive allows you to follow your favorite communities all in one place.

    Follow on Community Hive
  • Similar Content

  • Posts

    • I am not aware of travel cases for internal drives. Usually you have the drive and once you have made sure you own static electricity is discharged on your body, open the computer and unplug the power cable and data cable to the HD. Then you unscrew the screws holding the drive in. Put the drive into an Anti-Static bag and then usually into a box that has foam padding on all sides to protect the drive and then tape it up to close it.  With both drives in their proper storage bags, you can then have both drives in between foam insulation for handling any dropping of the box, etc. Pack them in a box and tape shut, should then easily handle going through your carry on or checked in luggage. To ship a hard drive, you need to: Secure the hard drive in its original packaging or anti-static bag. If you don't have an anti-static bag, place the drive into a zipped freezer bag to prevent any moisture getting into the drive during transit. Sandwich the drive between foam or wrap it in bubble wrap to absorb any minor shocks. Put the hard drive in a padded shipping box. Close and seal the box. Label your package. Amazon.com : hard drive shipping box This is pretty much all you need.
    • Either a co-pilot first time landing or something truly went wrong on the plane.
    • The incoming rectangular lamps on many GM cars in that era made them much more attractive.  They made a big difference. Now, as far the powerplant went, the notion of 500 cubic inches was mindboggling even during the malaise era.  If you want to see someone's jaw drop, tell a European that their engines have 8200 cc or 8.2 liters.  For those who aren't driving the occasional Mustang or Camaro you see, they freak out at anything over 2,500 or 3,000 cc.
    • Thank you for the response. I want to reinstall them into the computers, especially the "newer" one.  The old one has been a real champ.   The reason for not leaving them in the desktop is that the basic tower might have to be transported ... and not by me.  That means it will be out of my possession for a while.  Since the HDs would be traveling with me, they'll have to get scanned through airport security a time or two.  I'm guessing that shouldn't mess with the data.   I've already backed up the C drive on several large 1 TB portable hard drives.  I don't want to touch the basic functions and files on the computers since I don't know how that all works.  I stay away from the drives and files I am not familiar with. I tend to donate other things to charity.   I did give the Regal I once owned to charity.   A good friend told me that, about a month or two later, he saw it being driven around the city by its new owner and we had a good laugh. This is what I want to do.  I'm just trying to figure out if the guy or gal at Office Depot can size a case based on looking up the unit and the HD in it.  Any ideas on that part?  Or should I do that and approximate the size and weight of the part to get the cases?
    • I'm wondering about a lot of things related to this.  I am sure that, sadly, the passengers inside were jolted.  This is way different from a rough landing. Why was it even necessary to do it?  What was going on at the airport property at that time?  How does one even pull this off?  I've seen some vids of where they barely touch and then go off again, but this one looks way more complicated.
  • Who's Online (See full list)

  • My Clubs

×
×
  • Create New...

Hey there, we noticed you're using an ad-blocker. We're a small site that is supported by ads or subscriptions. We rely on these to pay for server costs and vehicle reviews.  Please consider whitelisting us in your ad-blocker, or if you really like what you see, you can pick up one of our subscriptions for just $1.75 a month or $15 a year. It may not seem like a lot, but it goes a long way to help support real, honest content, that isn't generated by an AI bot.

See you out there.

Drew
Editor-in-Chief

Write what you are looking for and press enter or click the search icon to begin your search

Change privacy settings