Jump to content
Create New...
  • William Maley
    William Maley

    As the Diesel Emits: CARB Admits A Full Fix Might Not Be Possible For All Volkswagen TDI Vehicles

      A CARB Offical Says Not All of the Affected Volkswagen TDI Vehicles Will Be Fully Fixed

    The big stumbling block for Volkswagen and the EPA/California Air Resources Board (CARB) has been trying to figure out a fix for diesel vehicles with illegal software. Ever since CARB rejected Volkswagen's first proposal back in January, the three have been in negotiations. But now, an official from CARB says some vehicles may only get a partial fix.

     

    Speaking at a legislative hearing in California yesterday, chief of the California Air Resources Board enforcement division Todd Sax said it might not be possible for Volkswagen to provide a compliant fix for all of the affected models.

     

    "Our goal has been to fix the vehicles and return them to their certified configuration as expeditiously as possible. Unfortunately, this may not be possible," said Sax.

     

    He believes there isn't a fix that could comply with either emission standards or onboard diagnostic requirements.

     

    "We will have to decide what the best approach is to dealing with these vehicles, and one of the options potentially would be to accept something less than a full fix," explained Sax.

     

    Newer TDI models use AdBlue diesel exhaust fluid to clean up emission and it is expected a software update will bring them into compliance. Older TDI models feature lean NOx traps (LNTs) to clean up emissions. These models need extensive modifications to bring them into compliance which could cost Volkswagen a lot of money.

     

    Sax was quick to point out that a compromise hasn't been agreed on and all of the parties are still in discussions. But if this option was taken, Volkswagen would need to pay penalties to mitigate the harm caused by leaving these vehicles on the road.

     

    Source: Reuters

    User Feedback

    Recommended Comments



    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest
    Add a comment...

    ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.


  • google-news-icon.png



  • google-news-icon.png

  • Subscribe to Cheers & Gears

    Cheers and Gears Logo

    Since 2001 we've brought you real content and honest opinions, not AI-generated stuff with no feeling or opinions influenced by the manufacturers.

    Please consider subscribing. Subscriptions can be as little as $1.75 a month, and a paid subscription drops most ads.*
     

    You can view subscription options here.

    *a very limited number of ads contain special coupon deals for our members and will show

  • Community Hive Community Hive

    Community Hive allows you to follow your favorite communities all in one place.

    Follow on Community Hive
  • Similar Content

  • Posts

    • I am not aware of travel cases for internal drives. Usually you have the drive and once you have made sure you own static electricity is discharged on your body, open the computer and unplug the power cable and data cable to the HD. Then you unscrew the screws holding the drive in. Put the drive into an Anti-Static bag and then usually into a box that has foam padding on all sides to protect the drive and then tape it up to close it.  With both drives in their proper storage bags, you can then have both drives in between foam insulation for handling any dropping of the box, etc. Pack them in a box and tape shut, should then easily handle going through your carry on or checked in luggage. To ship a hard drive, you need to: Secure the hard drive in its original packaging or anti-static bag. If you don't have an anti-static bag, place the drive into a zipped freezer bag to prevent any moisture getting into the drive during transit. Sandwich the drive between foam or wrap it in bubble wrap to absorb any minor shocks. Put the hard drive in a padded shipping box. Close and seal the box. Label your package. Amazon.com : hard drive shipping box This is pretty much all you need.
    • Either a co-pilot first time landing or something truly went wrong on the plane.
    • The incoming rectangular lamps on many GM cars in that era made them much more attractive.  They made a big difference. Now, as far the powerplant went, the notion of 500 cubic inches was mindboggling even during the malaise era.  If you want to see someone's jaw drop, tell a European that their engines have 8200 cc or 8.2 liters.  For those who aren't driving the occasional Mustang or Camaro you see, they freak out at anything over 2,500 or 3,000 cc.
    • Thank you for the response. I want to reinstall them into the computers, especially the "newer" one.  The old one has been a real champ.   The reason for not leaving them in the desktop is that the basic tower might have to be transported ... and not by me.  That means it will be out of my possession for a while.  Since the HDs would be traveling with me, they'll have to get scanned through airport security a time or two.  I'm guessing that shouldn't mess with the data.   I've already backed up the C drive on several large 1 TB portable hard drives.  I don't want to touch the basic functions and files on the computers since I don't know how that all works.  I stay away from the drives and files I am not familiar with. I tend to donate other things to charity.   I did give the Regal I once owned to charity.   A good friend told me that, about a month or two later, he saw it being driven around the city by its new owner and we had a good laugh. This is what I want to do.  I'm just trying to figure out if the guy or gal at Office Depot can size a case based on looking up the unit and the HD in it.  Any ideas on that part?  Or should I do that and approximate the size and weight of the part to get the cases?
    • I'm wondering about a lot of things related to this.  I am sure that, sadly, the passengers inside were jolted.  This is way different from a rough landing. Why was it even necessary to do it?  What was going on at the airport property at that time?  How does one even pull this off?  I've seen some vids of where they barely touch and then go off again, but this one looks way more complicated.
  • Who's Online (See full list)

    • There are no registered users currently online
  • My Clubs

×
×
  • Create New...

Hey there, we noticed you're using an ad-blocker. We're a small site that is supported by ads or subscriptions. We rely on these to pay for server costs and vehicle reviews.  Please consider whitelisting us in your ad-blocker, or if you really like what you see, you can pick up one of our subscriptions for just $1.75 a month or $15 a year. It may not seem like a lot, but it goes a long way to help support real, honest content, that isn't generated by an AI bot.

See you out there.

Drew
Editor-in-Chief

Write what you are looking for and press enter or click the search icon to begin your search

Change privacy settings