Jump to content
Create New...
  • 💬 Join the Conversation

    CnG Logo SQ 2023 RedBlue FavIcon300w.png
    Since 2001, Cheers & Gears has been the go-to hub for automotive enthusiasts. Join today to access our vibrant forums, upload your vehicle to the Garage, and connect with fellow gearheads around the world.

     

  • Drew Dowdell
    Drew Dowdell

    Lincoln Introduces the Corsair Grand Touring

      ...Corsair gets a plug-in option...

    Los Angeles - At the Los Angeles Auto Show, Lincoln introduced the Lincoln Corsair Grand Touring, a plug-in hybrid trim.  Based on the standard Corsair, the Grand Touring's powertrain consists of a 2.5-liter Atkinson-cycle four-cylinder gas engine and a permanent magnet synchronous motor.  The combined output based on Lincoln's calculations would be roughly 266 horsepower.  Electric All-wheel drive powers the rear wheels.  EV range is targeted at 25 miles EPA. 

    Power is conveyed through a PowerSplit electric continuously variable transmission with two electric motors working together to provide very smooth acceleration. 

    In addition to the five modes normally available to Corsair drivers, two additional modes are available on the Grand Touring;  Preserve EV mode recharges and saves battery power for later, the engine and motor work continuously to deliver full power.  The battery can be recharged up to 75 percent while in this mode. Pure EV mode is designed to keep the vehicle in all-electric mode as much as possible, only using the gasoline engine when the power demands exceed the electrical capabilities of the vehicle. 

    The Lincoln Corsair Grand Touring will be built in Louisville Kentucky and will go on sale summer of 2020. 

    User Feedback

    Recommended Comments



    2 minutes ago, balthazar said:

    There are a number of other brands and materials that are far more cost-effective than Dynomat, which is hugely overpriced, IMO. I did the floor/ firewall/ rear bulkhead on my B-59 with a heavy foil-faced butyl rubber product and it cost me less than $50. I am looking for something to do the roof, and haven’t done the doors yet.

    Cool, please share the site for the material, always looking for options as I agree Dynomat while very effective, is expensive.

    Link to comment
    Share on other sites




    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest
    Add a comment...

    ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.




  • Support Real Automotive Journalism

    Cheers and Gears Logo

    Since 2001, Cheers & Gears has delivered real content and honest opinions — not emotionless AI output or manufacturer-filtered fluff.

    If you value independent voices and authentic reviews, consider subscribing. Plans start at just $2.25/month, and paid members enjoy an ad-light experience.*

    You can view subscription options here.

    *a very limited number of ads contain special coupon deals for our members and will show

  • Similar Content

  • Posts

    • It's amazing how a leather wrapped steering wheel changes the experience at the wheel for the better (it seems to make for an almost different car from the model with a urethane steering wheel).
    • Another thing to think on is the evidence bullet proof? Sadly, the same type of people who have said an eye for an eye, death penalty if you took a life have convicted others with hate in their heart only to have science prove the convicted innocent.  In this regards I wish all guns had palm / finger tip readers to confirm who last fired the gun. While others might say the death penalty is cruel, how is it when the person if proved beyond a reasonable doubt took a life? What about serial killers who are sitting for life, a burden on society in jail because folks feel there should be no death penalty and yet they took multiple lives themselves. Would it not be better for society if that person was no longer around, a burden on the tax payers? Many good questions to be asked. Lets take this a step further, auto makers who due to a focus on profits take shortcuts on safety of an auto, who should be held accountable for the deaths related to their products and how do you hold them accountable? An example of profit before safety, FORD PINTO Details of the Pinto's flawed fuel system: Location and construction: The sheet-metal gas tank was placed behind the rear axle, a design common at the time, but the Pinto's tank was made with exceptionally thin walls. It was held in place by two metal straps. Vulnerable parts: During rear-end impacts, bolts protruding from the differential housing could puncture the thin-walled tank. Additionally, the fuel-filler neck could tear away from the tank itself. Internal cost analysis: Internal Ford documents revealed that engineers were aware of the risks in pre-production crash tests and considered inexpensive fixes, including adding a rubber bladder to the tank. Alternative designs rejected: Engineers considered safer alternative designs, such as placing the tank above the axle (a design used on the Ford Capri), but this was rejected due to cost and styling constraints. Final design choice: Executives opted not to make these changes after a cost-benefit analysis concluded it would be cheaper to pay out potential lawsuits and settlements than to implement the repairs.  So who do you hold accountable for the deaths?
  • Who's Online (See full list)

    • There are no registered users currently online
  • My Clubs

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Hey there, we noticed you're using an ad-blocker. We're a small site that is supported by ads or subscriptions. We rely on these to pay for server costs and vehicle reviews.  Please consider whitelisting us in your ad-blocker, or if you really like what you see, you can pick up one of our subscriptions for just $1.75 a month or $15 a year. It may not seem like a lot, but it goes a long way to help support real, honest content, that isn't generated by an AI bot.

See you out there.

Drew
Editor-in-Chief

Write what you are looking for and press enter or click the search icon to begin your search